How to convert Jetflow 3 piston
Published：2014/11/25
Step1：Open
Unscrew and remove the rear cap as shown.
Step2：Open
Use the tip of a screwdriver to loosen the
rear plastic cartridge bung.
Step3：Open
Pull on the rear cartridge bung and
remove it from the barrel.
Step4：Ready
Source sachet plunger/bung assembly (Cox PN: 7A1082).
Step5：Load
Insert the plunger into the rear end of the barrel.
Step6：Load
Carefully pack the plunger cord into the barrel.
Step7： Load
Push the sachet bung firmly
into the end of the barrel.
Step8：Load
Screw on the rear cap and ensure that the
end cap is a tight fit to the barrel.
Key：
